Issue:
While you install Exchange Server 2007 SP1 or Exchange Server 2010 Beta on Windows 2008, you might get error while installing the Hub Transport role:
Hub Transport Role Failed
Error:The execution of: "$error.Clear(); if ($RoleStartTransportService) { start-SetupService -ServiceName MSExchangeTransport }", generated the following error: "Service 'MSExchangeTransport' failed to reach status 'Running' on this server.".
Service 'MSExchangeTransport' failed to reach status 'Running' on this server.
or
Hub Transport Role Failed
Error:The execution of: "$error.Clear(); install-ExsetdataAtom -AtomName SMTP -DomainController $RoleDomainController", generated the following error: "An error occurred with error code '2147504141' and message 'The property cannot be found in the cache.'.".
An error occurred with error code '2147504141' and message 'The property cannot be found in the cache.'.
Resolution:
Aparently, this normally happens when you disable IPv6 in Local Area Connection.
This is due to the behavior of IPv6 in Windows Server 2008, when you disable IPv6 in Local Area Connection on Windows 2008 server.
Either enable IPv6. Or else, if you wish to disable IPv6, you have to make note that IPv6 is not disabled on tunnel interfaces if you disable IPv6 in Local Area Connection. By default, IPv6 is enabled in Windows Server 2008. If you want to disable IPv6 for any reasons, you have to use Registry Editor to completely disable IPv6.
To completely disable IPv6 on a Windows Server 2008-based computer yourself, follow these steps:
Open Registry Editor.
Locate the following registry subkey:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\Tcpip6\Parameters
In the details pane, click New, and then click DWORD (32-bit) Value.
Type DisabledComponents, and then press ENTER.
Double-click DisabledComponents, and then type ffffffff in Hexadecimal or 4294967295 in Decimal.
Note: If the setup still fails, remove IPv6 entry from the hosts file available at %systemroot%\system32\drivers\etc
----------------------------------------------------------------------------------------
3 comments:
great information dude - It really helped me - thanks moah
I'm getting this error message when installing on a fresh Server 2008 R2 SP1 box which has been promoted to a domain controller. This is a test box used for testing various configurations so please skip the usual "Microsoft doesn't recommend this" crap. IPv6 isn't disabled on the box but is configured with a self assigned address. We have this configuration working on a second test box which was loaded 6 months ago. We have tried to load it before any updates and after updates with the same result. If I have to I'll create a virtual machine as a domain controller for our test.local domain.
I hadn't disabled IPv6 and it bit me! Heres some more information that might be helpfull,
Exchange 2010 Install Error - 'Service 'MSExchangeTransport' failed to reach status 'Running' on this server'
Pete
PeteNetLive
Post a Comment